|
|
This BTG
all-stainless steel fuel injection
performance system was designed from the
ground up with absolute performance,
quality and longevity in mind. This
system features the use of aviation
grade stainless steel, polished to a
mirror finish that will never rust or
corrode, regardless of the climate the
system is exposed to. The hardware
carries a grade 5 or higher
specification where needed using
aerospace standards. The support systems
are carefully designed for proper
support and vibration isolation to
reduce material fatigue for long service
life. Custom designed boots and adaptors
insure ease of installation with super
clean under-hood aesthetics. The
high-flow-capacity basket-type filter,
made famous by K&N, is sized
specifically for this system and carries
a lifetime warranty. The system features
a "Cold-Air" baffle to block as much
engine heat as possible from the filter
inlet area to maximize the density of
the intake charge. This intake attaches
at the turbo inlet, replacing the entire
factory air box and baffle. Get true HP
gains, better intake sonic quality, and
extreme good looks for your GT Turbo's
engine! This unit has not yet been
approved by the California Air Resource
Board (C.A.R.B.) |
